How To Light Pilot On Gas Fireplace With Remote. You may need to press the dial in to turn it and may also need to hold the dial depressed at the ‘pilot’ position for a short while to ensure that the pilot stays alight. First, you must understand how the different components function and follow the correct procedure when lighting a gas fireplace using an electronic ignition system.

Relighting Your Heat & Glo® Standing Pilot Fireplace Video from

Remember to shut the gas supply valve off (picture #1). Slightly press the fireplace’s valve knob if it remains lit. If the pilot does not light, wait 5 minutes and try again.

If The Log Set Has A Switch On It, Place It In The Off Position.

It should usually run parallel to the gas line when it is on. If the pilot light goes out, repeat steps 5 & 6. This makes it simple to start the fireplace when it’s cold outside, but shutting off the pilot while it warms up is a good idea.

While Holding Down The Pilot Button, Light A Match Close To The Fire’s Piping.

Use the temperature and timer modes to maximize your. Other gas fireplaces may have a separate spark ignitor button that needs to be pressed alongside the dial. If the pilot does not light, wait 5 minutes and try again.

See also  Acting Lessons Game Wiki

Your Remote Is Being Reset And Ready To Use.

After lighting the pilot, continue to hold the control knob in for about 30 seconds, or the pilot may go out. From off position, turn gas control knob (reads off, on & pilot) counterclockwise to pilot position. Press the control knob down and hit the ignition switch.

Turn The Safety Control Valve Knob To The Pilot Position.

Remember to shut the gas supply valve off (picture #1). At the pilot position you will be able to push the knob the maximum amount toward the valve. Refer to your user manual for a.

Tap The Switch Until The Pilot Light Ignites.

How to light your pilot. Shut off the heat n glo fireplace’s gas supply valve. Once the pilot stays lit by itself, turn the gas flow knob to the “on” position.

Leave a Reply

Your email address will not be published.